Filter Panel - Native Instruments Hypha Manual

• + (Filter Panel): Opens the Filter panel that provides additional filter settings, including the filter
type, resonance, and modulation. For more information, refer to
• Glide: Adjusts the duration of the glissando effect, which makes one pitch glide to the next
when playing a second MIDI note at the same time. Glide will only take effect if Play Mode is
set to Mono or Legato.
• Play Mode: Selects one of three modes that determine the Instrument's response to
MIDI input. Poly allows multiple notes to be played polyphonically. Mono only allows one
monophonic note to be played at the same time. Legato only acquires new pitch information
when playing a second MIDI note at the same time without starting a new note event.
• Chord: Selects a chord to be played when pressing a single key. When Off is selected, keys
trigger individual notes. You can open the drop-down menu by clicking on the name and select
an entry from the list. Alternatively, you can use the left and right arrow buttons to select the
previous or next entry, respectively.
• Vol Envelope: Adjusts the Instrument's volume envelope, which consists of attack, decay,
sustain, and release stages. You can adjust each envelope stage by clicking and dragging the
individual segments in the display.

Filter Panel

The Filter panel provides additional filter settings, including the filter type, resonance, and
modulation.
The panel consists of the following menus and parameters:
• Filter Type: Selects either the Lowpass or Highpass filter type. When Lowpass is selected,
frequency content above the cutoff frequency is attenuated. When Highpass is selected,
frequency content below the cutoff frequency is attenuated.
• Resonance: Adjusts the resonance amount of the filter. Turning the control to the right makes
the frequency content at the cutoff frequency more pronounced.
• Vel->Freq: Adjusts the amount of velocity sensitivity for the cutoff frequency. When set to 0,
the cutoff frequency does not change depending on note velocity. When turning the control to
the right, the cutoff frequency changes according to the note velocity to a variable degree.
• Env Amount: Adjusts the amount of modulation applied from the the Filter Envelope to the
cutoff frequency.
• Filter Envelope: Adjusts the Instrument's filter envelope, which consists of attack, decay,
sustain, and release stages. You can adjust each envelope stage by clicking and dragging
the individual segments in the display.
M A I N P A G E
Filter Panel.
8