Advertisement
OPERATION
1. HEAD PHONES
To listen in privacy or monitor the audio source inputs so you can locate
an
exact passage or section before mixing it, plug a pair of stereo
headphones
with a 1/4 inch plug into the PHONES jack on the lower right front corner of
the mixer.
2. MONITORING THE INPUTS
A.Set POWER
ON/OFF to ON to turn on the mixer's power.
The POWER LED
indicator lights.
B.Turn on the audio input source
you want to mix, and set it to play (or
continuously talk into microphone).
C.Set the CUE ASSIGN
to the audio input sources
(MIC/AUX, CH 1, CH 2,
CH 3, or CH 4) you want to monitor. so you can decide when to mix in
each input and play them through your amplifier system or record them on
your tape deck.
D.Turn
the CUE
LEVEL
control
to adjust
the headphone
volume
without
effecting the overall mix.
3. MIXING THE INPUTS
A.The maximum available audio input sources you can mixing are:
МІС
: DJ MIC and AUX MIC.
PHONO: PHONO 1 and PHONO 2, To mix the turntable connected to the
< - PHONO jacks.
LINE
: LINE 1, LINE 2, LINE 3, LINE 4, LINE 5, and LINE 6. To mix any
high-level output audio sources connected to the LINE jacks.
B.Set the selected audio input sources to play.
C.Set the corresponding MIC, PHONO,
and LINE volume controls to approxi-
mately 8-10.
D.Set the INPUT DEVICE selector as desired.
AUX : AUX MIC or AUX LINE.
CH 1: PHONO i or LINE 1.
CH 2: PHONO 2 or LINE 2.
СН 3: LINE
З or LINE 4.
CH 4: LINE
5 or LINE 6.
Advertisement
