Summary of Contents for XtremepowerUS 75166
- Page 2 PART NO. ITEM NO. DESCRIPTION 47151001 Treads 5760101000 Hinges 47151006 Small support 5760100000 Storage liner 47151003 Side Walls 5760102080 Foam Strip 47151005 Medium Support 47151004 Big Support 5212012000 ScrewsST4.8*20) 5244006000 Gasket 5212005000 Screws(ST3.9*11.6)
- Page 3 Tools Needed Rubber Mallet; Cordless Drill; Drill Bit 2. Warning and Caution a) Check building codes/premitting Please consult your local Building Department before installation of your step and equipment in order to reduce the risk of drowning, electrocution, falls, or other serious injury or death. Equipment installation must comply with the codes of authority having jurisdiction and may require permits(e,g.,building, plumbing, electrical, zoning, etc.).
- Page 4 Drillφ5MM STEP 1: Install 2 self-adhesive pads on each of STEP 2: Pre-drill φ5mm pilot holes at the end of the sidewalls. the three supports. See image above. Drillφ3.5MM Drillφ3.5MM STEP 4: Place the medium support over the two STEP 3: Mark the position on both big and small locking tabs on the sidewalls.
- Page 5 STEP 7: Place the tapered edge into the groove of the big support to install the bottom tread. Apply pressure to force the tapered edge into the groove. Tap the front of the tread with the rubber mallet while holding the tread in place. Tap down gently on the top of the tread until sealed on the locking tabs.
- Page 6 STEP 12: Open the above tread and place STEP 11: Secure both ends of the sidewall with 2 x ST4.8*20 screws. the storage liner into the tread and fix with screws and gaskets. Open state Off state Warning: To reduce the risk of drowning,falls,paralysis,electrocution, or other serious injury or death, use the step system properly.