Sound Menu - Philips 28PW9527 Instruction Manual

Sound menu

Sound Features
TV
Volume
Equalizer
(Loudness)
Headphone volume
Surround mode
(Dual I-II)
(Mono/Stereo)
(Nicam/Analogue)
(3D effect)
AVL
Delta volume
(Audio only)
Smart sound
Surround Modes
Dependent on the sound signal broadcasted, select one of the
Surround modes.
Stereo
This mode reproduces only the left and
right front sound signals.
You only hear a stereo sound if the
broadcast which you are receiving is
transmitted in stereo or nicam stereo.
(optimal with Dolby Surround broadcasting)
Dolby 3 Stereo
The sound signal is now distributed over
the front left, the front right and the centre
TV loudspeakers.
The rear loudspeakers do not produce any
signal.
(optimal with Dolby Surround broadcasting)
3D Surround
3D Surround enables you to experience the
effect of Dolby Surround Pro Logic *
without the need of having rear speakers
connected or activated.
The graphical representation of the rear
loudspeakers is replaced by the symbol ®r.
Select the level of
3D effect
With two extra front loudspeakers connected
Press the cursor right to select
Select the menu items in the Sound menu with the cursor up/down and adjust the
settings with the cursor left/right.
Remember, control settings are at normal mid-range levels when the bar scale is
centred.
Note:
- Some menu items are only available in case of a Cinema Link configuration and when
- Dual X is only available with dual sound transmission.
- Mono/Stereo is only selectable in case of analogue stereo transmission.
- Nicam/Analogue is only selectable in case of Nicam transmission.
- Surround modes can not be modified when a headphone has been connected and the
with the cursor left/right.
To enhance the sound reproduction of your TV you may connect two extra front
loudspeakers via an external amplifier. See Connect Peripheral Equipment, Extra
loudspeakers/Amplifier, p. 20.
In the Surround modes
your amplifier as in these modes the internal TV speakers produce only centre
sound.The subwoofer speaker is muted.
Note: If extra front speakers are connected and selected, all internal TV speakers produce
centre sound in the surround modes Pro Logic, Dolby 3 Stereo and 3D Surround.
*
'Dolby' 'Pro Logic' and the double-D symbol
Manufactured under license from Dolby Laboratories Licensing Corporation.
the Cinema Link is activated. Others are steered by the audio receiver instead of by the
TV. See the separate Cinema Link booklet supplied.
mode is always stereo.
Hall
to add surround sound to a broadcast which is not encoded
Dolby Surround or to a mono signal.
Pro Logic
or programme marked with G Dolby Surround.This mode is
especially recommended for such programmes or movies.
Dolby Pro Logic signals are also present on some DVD tracks.
Note: Normal stereo broadcast is not always encoded to produce a
rear surround sound.
Note: In case of a Cinema Link configuration connected, the surround
modes of the receiver can be selected.
Pro Logic and Hall can only be reproduced if Surround speakers is set
to Yes in the Setup, Speakers menu, p. 9, and rear speakers are
connected.
+ ext. amp
.
Sound
The special sound signal is distributed over
the rear loudspeakers which creates a hall
effect from the rear.
The centre loudspeaker does not
reproduce any signal.
This mode is recommended when you wish
(with Dolby Surround broadcasting)
In addition to the left and right internal
speakers, the centre and the rear surround
loudspeakers reproduce the Dolby
Surround Pro Logic sounds.
This sound is always present in the movie
is added to indicate that you should switch on
are trademarks of Dolby Laboratories Licensing Corporation.
Use of the menus
13