Samsung AQV12ACME Service Manual page 28

[ippesotan, Ue cli ease oI
Remote controller operation
method as per the step
Applicable key
Troubleshootin}
Display status
4th step
Method)
After completion of 3rd step,
and if the MODE KEY is
pressed once,
1. 1~3 steps are saved
internally
2. tf the first number at the
time is "1", it is correct and
so go to 5th step
4¢ If pressing mode key and
the first digit becomes 0, the
screen of 1~3 steps can be
seen.
w
gEOOD
@ %
i
5th step
Method)
Pressing the marked key to
input the option number.
example} 142285
Result}
if it displays as shown in the
right
go to the 6th step
6th step
Method)
When pressing the
operation ON/OFF key with
the direction of remote
controller for set, the sound
"Ding, or Diriring is heard
and then the input of option
is completed.
3 Refer to the right side if
the error appears.
ERROR MODE
1. When the lamps of (STANDARD(@),
NATURE((®)), TIMER( @)) is flickering + failute
of option input
After removing the set power cord and insert it
again, pressing the operation on/off key to retry
and if the condition is same, EPROM is
deffcective or misinsertted. So replace the PCB.
Samsung Electronics
int
2. When all lamps of indoor unit( 3 sg, ag) are
flickering with the sound of Dididiring,
~> The current option input is different from that
of already input one: Check the option number
correctly and if it is correct, press the key once
more to input the option. (check correctly)
— If the option is not input at the time and all
lamps are continuously flickering ; since it is the
case that the option number is out of the input
range, check the option number again and do
again the steps from 1 - 6steps