Download Print this page

Titan Lifts XL Tool WB-350 Factory Reset

Turn machine ON. There should not be any tire/rim on shaft.

Press the following sequence of buttons to do a Factory Code Reset.

1. Press Home button

2. Press DIS + button

Your screen will now display "SET UP"

3. Press House 2 Times

Your screen will now display "POS" and "some number"

4. Rotate shaft until "111" appears in the right window.

5. Hit "C" button.

WB-350 Factory Reset.

Table of Contents

Do you have a question about the XL Tool WB-350 and is the answer not in the manual?

Page 1 WB-350 Factory Reset. Turn machine ON. There should not be any tire/rim on shaft. Press the following sequence of buttons to do a Factory Code Reset. 1. Press Home button 2. Press DIS + button Your screen will now display “SET UP” 3.
Page 2 6. Rotate shaft until “55” appears in the right window. 7. Hit “C” button. 8. Rotate shaft until “111” appears in the right window. 9. Hit “C” button. Your screen will now display “COD” and “Set” Press Home key...
Page 3 Your screen will display “some number” on both sides Press DIS + repeatedly until “46” appears in the left window. Press home key. Your screen will now display “B-A” and “some number” Pull Distance Gauge out and put to Flange – note distance on distance gauge.
Page 4 Then press Home key. Your screen will now display “EL1” “005” Use DIS + or DIS – to change the number on the right to show 005 (in the unit of Gram) or 007 (in the unit of Ounce) Press Home key. Your Screen will now display “Tur”...
Page 5 ------------------------------------------------------------------------------------...

Xlt wb-350