Manually adjust picture settings
1
Press .
2
Select [Setup] > [TV settings] > [Picture],
then press OK.
3
Select one of the following settings, then
press OK.
[Smart picture]: Access predefined smart
•
picture settings.
[Reset]: Reset to factory default settings.
•
•
[Contrast]: Adjust the intensity of backlight
areas, while the video contents are kept
unchanged.
[Brightness]: Adjust the intensity and
•
details of dark areas.
•
[Colour]: Adjust colour saturation.
[Hue]: Compensate for colour variations.
•
•
[Sharpness]: Adjust sharpness in the image.
[Noise reduction]: Filter and reduce noise
•
in an image.
[Tint]: Adjust the colour balance in an
•
image.
•
[Custom tint]: Customise tint setting.
(Only available if [Tint] > [Custom] is
selected)
[Digital Crystal Clear] / [Pixel Plus] /
•
[Pixel Plus HD]: Fine-tune each pixel to
match surrounding pixels. This setting
produces a brilliant, high-definition image.
•
[HD Natural Motion]: For selected
models. Minimise juddering effects and
enhance picture smoothness.
[100Hz Clear LCD] / [120Hz Clear
•
LCD]: For selected models. Reduce
motion blurring and make picture
clearer.
[Advance sharpness]: Enable superior
•
picture sharpness.
[Dynamic contrast]: Enhance contrast.
•
[Medium] setting is recommended.
[Dynamic backlight]: Adjust brightness
•
of the TV backlight to match lighting
conditions.
[MPEG artifact reduction]: Smooth
•
out transitions on digital pictures. You
can switch this feature on or off.
EN
16
[Colour enhancement]: Make colours
•
more vivid and improve the details
in bright colours. You can switch this
feature on or off.
[Gamma]: For selected models. Adjust
•
the midtone intensity in the picture.
Black and white are not affected.
•
[PC mode]: Adjust the picture when a PC
is connected to the TV via HDMI or DVI.
•
[Light sensor]: Adjust settings dynamically
based on the current lighting conditions.
[Picture format]: Change the picture
•
format.
[Screen edges]: Adjust the viewing area.
•
(when set to maximum, you may see noise
or the rough edge of an image).
[Picture shift]: If available, adjust the picture
•
position for all picture formats except for
[Auto zoom] and [Wide screen].
Change picture format
1
ADJUST.
Press
2
Select [Picture format], then press OK.
3
Select a picture format, then press OK.
Summary of picture formats
The following picture settings can be configured.
Note
•
Depending on the format of the picture source, some
picture settings are not available.
[Auto format]: For
selected models. (Not for
PC mode.) Automatically
display the suitable picture
format. If not, widescreen is
applied.
[Auto fill]: For selected
models. Adjust the
picture to fill the screen
(subtitles remain visible).
Recommended for minimal
screen distortion but not
for HD or PC.