Save Preset.24 - Peavey DPM C8 User Manual

Note:
These polarities work on all eight ranges. There are also polarities per range on the
Range Enables
screen (section 2.11). These work together as follows:
CtlAsgn Polarity
+
+
Range Polarity
POS
NEG
POS
NEG
2.13c Save Preset
Press the
SAVE
soft button and refer to section 2D.
Resulting Polarity
Positive
Negative
Negative
Positive
2.14 Slider A ssignment
Pressing the
Slider
soft button from any other controller assignment page accesses the following screen:
Slider Assi9n 61 Preset Maine
SIlderl
Und&fined
(03) A
SIider2 Main Uolume (0?) +
SIider3 Undefined (16) +
SIider4
Ba1ance
(68) +
IWheel
IButtori | Foot
-1
Sliders 1-4 correspond to the equivalently numbered sliders on the main panel.
2.14a Parameter Assignment
Place die cursor over the parameter to be assigned and select the desired assignment. Options are
OFF MIDI
controllers 01-120 channel pressure, pitch bend
(full range),
pitch bend
(up only) and
pitch bend
(down only).
Note:
Slider 1 defaults to being the data slider but this can be changed on the Global page (section 4.2). While
on any edit page, slider 1 will serve as the data slider; upon exiting to the main preset page, slider
1 will take on the function you assigned it.
2.14b Polarity Assignment
Polarity refers to the "sense" of the slider. To change polarity, press the
Polarity
soft button while the cursor
is on the slider to be edited.
Example: With Slider 1 assigned to main volume and positive polarity', moving the slider from bottom to top
increases the volume from zero to full on. With negative polarity assigned, moving the slider from bottom
to top decreases the volume from full on to zero.
Note:
Refer to the polarity table in section 2.13b.
2.14c Save Preset
Press the
SAVE
soft button and refer to section 2D.