ABW Cone Genie DS-CG-SRLARGE Instruction Sheet

Thank You for purchasing the Cone-Genie! We know you
will be amazed at how fast & proficient the Cone Genie is.
Please follow the below instructions to make your use as
simple as possible!
1: Find a convenient location to sit your Cone-
Genie–-close to your waffle maker.
2: Be sure the main control switch is turned
to off.
3: Plug in the GFCI Plug into a nearby outlet.
4: Your unit is set to the normal run time of
around 10 seconds. This can be adjusted
up or down if needed. See instructions
that follow for time adjustment.
5: Prepare your waffle cone & turn the Cone-
Genie switch to AUTO.
6: Pass your hand over the top of the yellow
photo sensor, which will activate the Cone-
Genie.
7: As the Cone-Genie turns insert your flat waffle
cone into the shaping area–follow the
arrows. See next page for diagram.
8: Your cone should be pulled into the device and
continue wrapping until the timer stops.
9: Slide the Shaping Tray to left–-allowing room
for you to remove the cone.
10: Prepare your next cone and make another!
ABW-INNOVATIONS LLC
www.cone-genie.com
INSTRUCTION SHEET
LAHAINA, HI 96761
www.abw-innovations.com
(256) 648-5172