Lithonia Lighting EDGR Installation Instructions

INSTALLATION INSTRUCTIONS for Lithonia Lighting EDGR & EDGRNY Models
FOR RECESSED EDGE-LIT LED EXIT SIGN
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS: When using electrical equipment, basic
safety precautions should always be followed, including the following:
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS
MAY RESULT IN DEATH , SERIOUS INJURY OR SIGNIFICANT PROPERTY
DAMAGE- For your protection, read and follow these warnings and instructions
carefully before installing or maintaining this equipment. These instructions do not
attempt to cover all installation and maintenance situations.
WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCON-
NECT FROM, OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
WARNING: RISK OF FIRE- Keep combustible material away from hot parts.
Observe lamp manufacturer's warnings, recommendations and restrictions on
lamp operation and maintenance. Make sure lamps are correctly installed.
WARNING: DO NOT USE ABRASIVE MATERIALS OR OTHER SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIX-
TURE, WHICH MAY RESULT IN PERSONAL INJURY.
WARNING: RISK OF PERSONAL INJURY- This product may have sharp edges. Wear gloves to prevent cuts or abrasions when
removing from carton, handling, installing and maintaining this product.
INSTALLATION INSTRUCTIONS
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
• Disconnect AC power and unplug battery before servicing (EL operation only).
• Consult your local building code for approved wiring and installation.
• UL Damp location listed standard. (0°C- 50°C)
• Do not let power supply cord touch hot surfaces .
• Do not mount near gas or electric heater.
• Do not install a damaged fixture.
• This product must be installed in accordance with the applicable installation codes and ordinances.
• All service shall be performed by qualified service personnel. This product must be installed and maintained in accordance with the
applicable installation codes by a person familiar with the construction & operation of the product and the hazards involved.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
PAGE: 1 of 5
Standard and New York Approved Models
(Emergency, non-Emergency and X2 Dual Circuit operation)
SAVE THESE INSTRUCTIONS! SAVE THESE INSTRUCTIONS
and deliver to owner after installation
AND DELIVER TO OWNER AFTER INSTALLATION