MedeScan NO ITCH Quick Start Manual

No Itch
Insect Bite Healer
QUICK START GUIDE
ON / OFF
Mode Button
Temperature
Selection
Battery
Compartment
How to ditch the itch
Press the On / Off button
Step 1
to power the No Itch ON
Make sure there is no
insect sting in the skin.
Your Medescan No Itch is
now powered on.
• Temperature setting 37
• Sensitive skin setting ON.
3 seconds treatment.
Solid Blue
Indicator
light.
Step 2
Place the
heating plate
directly on
the insect
bite for rapid
relief
Heat treatment begins on
contact and once you hear
the beep, the treatment is
complete.
When you treat an insect bite and you still feel the
itch, it could mean that you need to increase the
temperature. Go up as much as you can comfortably
accept. Higher temperatures are also suitable for
thicker skin areas like the elbow and heel.
42 C
o
Press and hold the temperature button. The
temperature will change from 37
The indicator light will change:
C
o
Blue
47 C
o
37 C Orange
o
Red
If the temperature is just right but you need a little
longer for better effect, you can change from
sensitive skin mode to regular skin mode or you can
42 C
repeat the treatment.
o
After switching the No Itch on, short press the power
button and the Mode will change from Sensitive skin
to Regular skin mode (3 seconds to 6 seconds
47 C
o
treatment). You can change the temperature
37 C
o
normally as instructed above.
Changing the temperature setting
C, to 42
o
= 37 C
o
= 42 C
o
= 47 C (Caution. HOT!)
o
Changing Treatment Mode
C to 47 C.
o o