Table of Contents
Advertisement
@ Adjustment of the recording level
- @ Set the PEAK-SIGNAL-CHECK
switch to the "OUT" position,
and adjustso that the indication needles do not fluctuate beyond
the "O dB" point.
With the PEAK-SIGNAL-CHECK
switch set to the "IN" position,
the scale is read up to the +6 dB mark on the lower part of the
meters.
With the PEAK-SIGNAL-CHECK switch set to the "OUT" position,
the scale is read up to the +3 dB mark on the upper pari of the
meters.
The needle
fluctuation for momentary
sound and for continuous
sound is shown in figure 7.
MONITORING
"Monitoring''
means to listen, using headphones, to the sound being
recorded at the same time it is being recorded. This is very convenient
for actual aural confirmation of the material being recorded.
To monitor, connect stereo headphones
(89) to the HEADPHONES
jack (HEADPHONES).
Note:
fn the same way as for playback, an amplifier can also be used for
monitoring. Note, however, if the recording is being made via a con-
nection made tothe RECORDING/PLAYBACK connection socket, that
monitoring can be done only with headphones.
HOW
TO USE THE PAUSE
BUTTON
(Timer recording of FM
broadcasts)
1. Connections
Connect the power source. (Refer to figure 9.)
Connect the sound source. (Refer to figure 6.)
and the recording of the FM broadcast will begin.
Notes:
1.
push the STOP button of this unit.
PLAYBACK
WITH
A TIMER
1. Insert the already-recorded tape cassette into this unit and make
connections to the power source and for playback.
3. Rewind the tape to the point from which the timer playback Is to
begin, push the PAUSE button, and then push the PLAY button.
4.
Set the timer to the desired time for beginning
of the pl ayback.
These
steps complete
the preparations
necessary
for playback
by a
timer. When the timer reaches the time to which it was set, thep layback
will begin.
Advertisement
Table of Contents
