Frequency Selection - Kenwood TH-225A Instruction Manual

@ FREQUENCY SELECTIONS
Two different methods are provided for frequency selection.
@ UP/DOWN key frequency selection
1 Pressing either the [£] or the [2] key momentarily
will cause the displayed frequency to change 1 step up
or down, respectively.
The step size is selected by pressing the [J and the
3/STEP key from 5 step sizes (5, 10, 15, 20, 25 kHz).
1 step up AO. 1 step down OX
2 Pressing the [2] or the [©] key for more than 1 se-
cond will cause the frequency to change up or down con-
tinuously until the key is released.
3 Pressing the followed by holding the [£] or the
[1 key will cause the frequency to change quite
FR ADL EO
Repeating this operation shifts the displayed frequency as
shown below.
fo Up by selected capa fe Down by selected SRF
Lower Limit Upper Limit Lower Limit Upper Limit
® Direct keyboard frequency entry
Press the key.
Enter the frequency to the nearest kHz.
For example
The receiver will not change frequency until all digits have
been entered.
If you should make an error before entering all digits, press
the [xa] key twice, and reenter all digits.
11