Advertisement
Power Cord
Multiple power cords may be supplied with this equipment. Use the appropriate one that
matches your country/region.
For the customers in the UK, Ireland, Malta and Cyprus
Use the power cord (A).
For safety reasons, the power cord (B) is not intended for above countries/regions and
shall therefore not be used there.
For the customers in other EU countries/regions and Israel
Use the power cord (B).
For safety reasons, the power cord (A) is not intended for above countries/regions and
shall therefore not be used there.
(A)
(B)
LAN cable
Use a Category 5e or higher Shielded Twisted Pair (STP) cable with high shielding
performance.
For Customers in the U.S.A. and Canada
The available scientific evidence does not show that any health problems are associated
with using low power wireless devices. There is no proof, however, that these low power
wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio
frequency energy (RF) in the microwave range while being used.
Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-
level RF that does not produce heating effects causes no known adverse health effects.
Many studies of low-level RF exposures have not found any biological effects. Some
studies have suggested that some biological effects might occur, but such findings have
not been confirmed by additional research. This equipment has been tested and found to
comply with FCC/ISED radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio
frequency (RF) Exposure rules.
For Customers in the U.S.A.
For question regarding your product or for the Sony Service Center nearest you, call 1-800-
222-SONY (7669) .
Supplier's Declaration of Conformity
Trade Name : SONY
Model : WW459276
Responsible Party : Sony Electronics Inc.
Address : 16535 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone Number : 858-942-2230
Important note on use of 5 GHz wireless LAN
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down through the
MAC, through the digital and analog baseband, and finally to the RF chip. Several special
packets are initiated by the MAC. These are the only ways the digital baseband portion will
turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the
transmitter will be on only while one of the aforementioned packets is being transmitted.
In other words, this device automatically discontinue transmission in case of either
absence of information to transmit or operational failure.
Frequency Tolerance: ±20 ppm
For Customers in Canada
5 150-5 350 MHz band is restricted to indoor operation only.
High-power radars are allocated as primary users (i.e. priority users) of the bands 5 250-
5 350 MHz and 5 650-5 850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
For Customers in Europe
IEEE802.11b/g/n
2 400 MHz
IEEE802.11a/n/ac
5 150 - 5 350 MHz
5 470 - 5 725 MHz
IEEE802.11a/n/ac
5 725 - 5 850 MHz
Bluetooth
2 400 MHz
Hereby, Sony Corporation declares that this equipment is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address:
https://www.compliance.sony.eu
Hereby, Sony Corporation declares that this equipment is in compliance with the UK
relevant statutory requirements.
The full text of the declaration of conformity is available at the following internet address:
https://compliance.sony.co.uk
For this radio equipment the following restrictions on putting into service or of
requirements for authorization of use apply in AT/BE/BG/CY/CZ/DK/EE/FI/FR/DE/EL/HU/
IE/IT/LV/LT/LU/MT/NL/PL/PT/RO/SK/SI/ES/SE/UK/UK(NI)/HR/IS/LI/NO/CH/AL/BA/MK/
MD/RS/ME/XK/TR:
5 150 - 5 350 MHz band is restricted to indoor operations only.
The power delivered by the charger must be between min 2.5 Watts required by the radio
equipment, and max 27 Watts in order to achieve the maximum charging speed.
USB PD fast charging
For customers who purchased their camera from a store in
Japan that caters to tourists
Note
Some certification marks for standards supported by the camera can be confirmed on the
screen of the camera.
Select MENU
Specifications
Camera
[System]
Camera Type:
Interchangeable Lens Digital Camera
Lens: Sony E-mount lens
[Image sensor]
Image format: 35 mm full frame,
CMOS image sensor
Effective pixel number of camera:
Approx. 24 600 000 pixels
Total pixel number of camera:
Approx. 25 200 000 pixels
[General]
Rated input: 7.2 V
Operating temperature:
0 to 40 °C (32 to 104 °F)
Storage temperature:
–20 to 55 °C (–4 to 131 °F)
Dimensions (W/H/D) (Approx.):
136.1 × 96.9 × 82.9 mm
136.1 × 96.9 × 72.8 mm
(from grip to monitor)
5 3/8 × 3 7/8 × 3 3/8 in.
5 3/8 × 3 7/8 × 2 7/8 in.
(from grip to monitor)
Compatible iPhone/iPad models
iPhone 14 Pro Max, iPhone 14 Pro, iPhone 14 Plus, iPhone 14, iPhone SE (3rd generation),
iPhone 13 Pro Max, iPhone 13 Pro, iPhone 13, iPhone 13 mini, iPhone 12 Pro Max,
iPhone 12 Pro, iPhone 12, iPhone 12 mini, iPhone SE (2nd generation), iPhone 11 Pro Max,
iPhone 11 Pro, iPhone 11, iPhone XS Max, iPhone XS, iPhone XR, iPhone X, iPhone 8 Plus,
iPhone 8, iPhone 7 Plus, iPhone 7, iPhone SE, iPhone 6s Plus, iPhone 6s, iPad Air (3rd,
4th, and 5th generation), iPad (5th through 10th generation), iPad mini (6th generation),
iPad Pro 12.9-inch (1st through 6th generation), iPad Pro 11-inch (1st through 4th
generation), iPad Pro 10.5-inch, iPad Pro 9.7-inch, iPad Air 2, iPad mini (5th generation),
iPad mini 4
(As of May 2023)
Trademarks/Licenses
•
is a trademark of Sony Group Corporation.
• Apple, iPhone and iPad are trademarks of Apple Inc., registered in the U.S. and other
countries.
• USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.
• Wi-Fi, the Wi-Fi logo and Wi-Fi Protected Setup are registered trademarks or trademarks
of the Wi-Fi Alliance.
• The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Sony Group Corporation and its
subsidiaries is under license.
• QR Code is a trademark of Denso Wave Inc.
• In addition, system and product names used in this manual are, in general, trademarks or
registered trademarks of their respective developers or manufacturers. However, the ™
or ® marks may not be used in all cases in this manual.
< 60 mW e.i.r.p.
< 35 mW e.i.r.p.
IMPORTANT – Read the End User Software License Agreement before using your Sony
product.
< 25 mW e.i.r.p.
Using your product indicates your acceptance of the End User Software License
< 10 mW e.i.r.p.
Agreement. The software license agreement between you and Sony is available at the
following URL:
(https://rd1.sony.net/help/di/el23/h_zz/)
• Use of the Made for Apple badge means that an accessory has been designed to
connect specifically to the Apple product(s) identified in the badge, and has been
certified by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory
standards.
(Setup) [Setup Option] [Certification Logo].
Mass (Approx.):
703 g (1 lb 8.8 oz) (including battery
pack, SD Card)
[Wireless LAN]
WW459276 (see name plate on the
bottom of camera)
Supported format:
IEEE 802.11 a/b/g/n/ac
Frequency band: 2.4 GHz/5 GHz
WW682266 (see name plate on the
bottom of camera)
Supported format: IEEE 802.11 b/g/n
Frequency band: 2.4 GHz
, 4.8 W
Battery charger BC-QZ1/BC-QZ1 T
Rated input:
100 - 240 V
, 50/60 Hz, 0.38 A
Rated output: 8.4 V
, 1.6 A
Rechargeable battery pack
NP-FZ100
Rated voltage: 7.2 V
Design and specifications are subject to
change without notice.
Additional information on this product and answers to frequently asked
questions can be found at our Customer Support Website.
©2023 Sony Corporation Printed in Thailand
Advertisement
