Kenwood TS-140S Instruction Manual page 22

2.
Press and hold the A/B key and turn on the power to
reset all user programmed data except the contents
of the Memory Channels.
RESET (-— -
from the speaker.
—) will again be sounded
4-4-3. Memory Channel
Memory Channel
Number Memory Channel
Date Entry
00 through 09 Standard Frequency and mode
10 through 19 Split
Receive and transmit frequency, mode
20 through 30 Programed Band Marker
Frequency, Highest operating frequency
Lowest operating frequency and mode
A.
Standard Memory Channels
These Memory Channels (00 to O9) are capable of
storing one frequency and one mode each.
. Split Memory Channels (SPLIT indicator on)
These Memory Channels (10 to 19) are capable of
storing separate transmit and receive frequencies
for use with 10 Meter repeaters,just to name one
possible application. These Memory Channels can
also be used as standard Memory Channels by
storing the same transmit and receive frequency.
. Programed Band Marker (* indicator on)
. Programed band marker (20 to 30) are capable of
storing specific band segments (highest operating
frequency and lowest operating frequency), and
mode. If the highest and lowest operating fre-
quencies are the same, then these Memory Chan-
nels will function as standard Memory Channels.
Channel 30 is also used to specify the limits of the
program scan function.
4-4-4. Memory Entry
2. Since these channels store both a low and high
frequency limit you can vary the operating fre-
quency thru out this specified range during
Memory operations. You can also change the
mode of these channels during Memory opera-
tions. An easy way to check the range of each
channel is to use the UP/DOWN switches.
These positions are quite useful when working
contests etc. You can program the band
segments that you want to work. Then if band
conditions change and you want to change to
another band you can simply select the desired
band segment by rotating the M.CH/VFO CH con-
trol. This makes for rapid frequency changes,
which are a definite aid in large contests, and it
keeps you in the band segment you want to use!.
A. Standard Memory Channel
Operation
Key
Beep
Remarks
1 Select the receive TUNING knob
frequency. BAND switch 1 short beep
2
Select the mode.
MODE keys
Morse code or
*:1
short beep can
be selected
by
1 short beep *
pressing the
CW/N key
and the
power switch ON. (Please refer to
Section 4-2-8)
3
Press the M.IN
M.IN
1 short beep
The M.SCR indicator will light.
key.
4
Select the
M.CH/VFO CH
Channels 10 through 19:
Memory Channel
control
The SPLIT indicator will light.
number.
Channels 20 through 30:
The * indicator will light.
5
Press the M.IN
M.IN
Long beep
The M.SCR indicator will OFF.
key.
Channels 10 through 19:
The SPLIT indicator will OFF.
Channels 20 through 30:
The ¥ indicator will OFF.
22