JAROLIFT TDEF10/14 Original Assembly And Operating Instructions page 41

Teaching in additional hand and wall transmitters
You can teach up to 15 transmitters into the receiver of the TDEF motors and thus
realize e.g. individual, group, and centralized control of your roller shutters.
To teach in further transmitters, you need a transmitter that has already been pro-
grammed (taught in).
1. Press the UP and DOWN buttons at the same time on a transmitter that has al-
ready been taught in.
2. Then press the STOP button 8x – also on the already taught-in transmitter.
3. The motor will vibrate briefly as confirmation.
4. Within 5 seconds, press the UP and DOWN buttons at the same time on the
new transmitter to be taught in.
5. Then briefly press the STOP button on the transmitter to be taught in.
The motor will vibrate briefly again as confirmation.
The code has now been copied to the new transmitter.
Already taught-in transmitter
UP and 8 x STOP
DOWN
Deleting the hand and wall transmitters
All taught-in (programmed) transmitters are deleted!
Individual deletion of a transmitter is not possible!
1. Press the UP and DOWN buttons at the same time on a transmitter that has
been taught in.
2. Then press the STOP button 6x.
3. Press the UP button within 10 seconds.
The motor will confirm the deletion of the transmitters by vibrating briefly.
New (additional) transmitter
UP and STOP
DOWN
SETTINGS
41