Cole & Bright 63726 Quick Start Manual

Solar powered + linkable persis+ security light

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

SOLAR POWERED + LINKABLE

PERSIS+ SECURITY LIGHT

IMPORTANT INFORMATION

• Keep these instructions safe for future reference.

• Your motion light and solar panel are both weatherproof.

• You can mount your motion light indoors, but your solar panel must be

installed outdoors to receive light from the sun.

• If using a step ladder, you may require a second person to help install

the solar motion light.

• Prior to installation, lay out all the components and check the part list

section in this manual.

• Never look directly into the solar motion light when illuminated.

• If you locate your light in the vicinity of windows or glass doors,

movement may trigger the sensor to turn the lights on. Locate your lights

with this in mind.

IMPORTANT: READ ALL SAFETY INFORMATION AND INSTALLATION IN-

STRUCTIONS BEFORE INSTALLING OR SERVICING THIS PRODUCT. SAVE

THIS MANUAL FOR FUTURE REFERENCE.

with

LINKABLE

63726

360°

Table of Contents

Need help?

Do you have a question about the 63726 and is the answer not in the manual?

Questions and answers

Summary of Contents for Cole & Bright 63726

Page 1 63726 with with 360° LINKABLE SOLAR POWERED + LINKABLE PERSIS+ SECURITY LIGHT PERSIS+ SECURITY LIGHT IMPORTANT INFORMATION • Keep these instructions safe for future reference. • Your motion light and solar panel are both weatherproof. • You can mount your motion light indoors, but your solar panel must be installed outdoors to receive light from the sun.
Page 2 Introducing 360° LINKABLE Radar 360° + LINKABLE is the new next-generation solar sensor light from Cole & Bright. The new “LINKABLE” technology turns a single security light into a potential chain of security lights. Radar 360° + LINKABLE requires no wires, hardware, or additional components - just another Radar 360°...
Page 3 OPERATING INSTRUCTIONS The switch located on the bottom of the solar light panel housing is to turn on the product and also to link your Radar 360˚+ linkable lights together (if you are creating a linked network) CHARGING YOUR RADAR 360˚ LIGHTS FOR THE FIRST TIME 1.
Page 4 LINKING YOUR RADAR 360˚ LIGHTS FOR THE FIRST TIME Only TWO (2) Lights (cont) 5. On the Secondary Light move the switch on the base to “S” position (right). 6. Press the LINK button located underneath the switch of both units simultaneously until the lights begin to ﬂ...
Page 5 SMART LIGHT SETTINGS Radar 360˚ is super smart and has 2 light settings on the same switch that is used to link the lights. Take note of the markings above and to the right of the switch. Goes from NO light to FULL brightness when triggered.
Page 6 LOCATING LIGHTS IN THE NETWORK FOR BEST RESULTS Radar360˚s has ultrasensitive sensors that detect movement at up to 7 metres in any direction from the light. We recommend that you link your lights around 5m apart for best results. If you locate a Radar360˚ + light in the vicinity of windows or glass doors, movement indoors will likely trigger the sensors and turn the light on.
Page 7 TOOLS REQUIRED (not included) Electric Power Phillips Pencil Ladder Level Drill Screwdriver Protection PARTS LIST wall inserts phillips screws solar panel light unit ground stake wall bracket GENERAL PRECAUTIONS Keep out of reach of children. PRE-INSTALLATION • • Carefully remove the ﬁ xture from carton and check that all parts are included. Carefully remove the ﬁ...
Page 8 approx.7 m TROUBLESHOOTING PROBLEM: : Light will not come on. Light will not come on. POSSIBLE CAUSES • Solar panel not in direct sunlight. • Solar panel not in direct sunlight. • Battery pack not fully charged. • Battery pack not fully charged. •...