FIG. 1 - CONTENT
• Thermostat
• Sensor
The thermostat is an electronic PWM/PI thermostat for temperature control by means of an NTC sensor located either
externally or internally within the thermostat.
The thermostat is for flush mounting in a wall socket. A baseplate for wall mounting is also available.
Product programme
WT01
Clock-thermostat with two sensors:
floor sensor and built-in room sensor.
FIG. 2 – WARNING: IMPORTANT SAFETY
INSTRUCTIONS
Disconnect the power supply before carrying out any installation or maintenance work on this thermostat and associated
components. The thermostat and associated components should only be installed by a competent person (i.e. a qualified
electrician). Electrical installation must be in accordance with appropriate statutory regulations.
WARMTECH WT01 Instructions
warmtech.com.au
| 8