HP 415E Operating And Service Manual page 7

Section П
Paragraphs 2-17 to 2-20
©
ADAPTER
FRAME
эу @
@ INSTRUMENT
SPACER
CLAMP
Figure 2-4. Two Half Modules in Rack Adapter
а. Connect Model 415E to AC source. Set POWER
switch to CHARGE and charge battery for а minimum
of 16 hours or overnight. Note: the battery can be
maintained in the charging state indefinitely without
damaging the battery. It will assume its fullcapacity,
1.25 ampere hour, and no more.
b. Set POWER switch to TEST position, the meter
needle indication should be within the BAT. CHARGED"
area (see Figure 3-1).
2-2
Model 415E
2-17. INSTALLING BATTERY AND INPUT
CONNECTOR.
2-19. REPACKAGING FOR SHIPMENT.
2-20. When returning an instrument to the Hewlett-
Packard Company, use the original packing material
(if foam type) if available or contact an authorized hp
Sales Office for assistance. If this is not possible, first
protect the instrument surfaces by wrapping in heavy
Kraft paper or with sheets of cardboard flat against
the instrument. Then protect the instrument on all
sides (use approximately 4 inches of packing material
designed specifically for package cushioning), pack in
а durable container, mark container clearly for proper
handling, and insure adequately before shipping.
Note
When an instrument is being returned to the
Hewlett-Packard Company for service or ге-
pair, attach atag tothe instrument specifying
the owner and desired action. Allcorrespon-
dence should identify the instrument by model
number and the full (eight-digit) serial number.
02152-1