Summary of Contents for Oaktree Products Mark V+
- Page 1 Oaktree Products, Inc. Mark V+™ Hearing Aid Suction Pump User Manual 1-800-347-1960 www.oaktreeproducts.com...
-
Page 2: Product Overview
Thank you for purchasing the Mark V+. Please read the instruction manual carefully before use. Product Overview The Mark V+ continues the legacy of the original Mark V. The Mark V+ offers the most powerful suction and quietest operation on the market. With the Mark V+ you can suction wax from hearing aids and earmolds and blow air to remove dust and debris from devices and surfaces. -
Page 3: What's Included
What’s Included • (1) Mark V+ Suction Pump • (2) Clear 36” Tubes (one for suction port and one for pressure port) • (2) Filter/Wand Assembly (one for suction port and one for pressure port) • (1) Set of Suction Needles •... -
Page 4: Rear View
Rear View Chamber Release Valve Chamber Release Valve Circuit Breaker Power Supply Circuit Breaker 4A DC 12/V/3.5A Assembly Instructions Insert one tube into the ports marked suction and pressure on the front panel of the Mark V+. Push tube in firmly. Pull on tube gently to see it holds. If not, push in again. The suction and pressure filter/wand assembly is attached to the opposite end of the tube by pushing the tip firmly into the tube. - Page 5 Operating Instructions Drying Chamber To use the drying chamber, push the POWER button in. Then push the Drying Chamber button “in” to activate chamber. Gently push the drying chamber lid down until the vacuum holds it firm. The motor will turn off automatically after 15 minutes of continuous use. To release the lid at anytime, turn off the POWER button and twist the Chamber Release Valve, located on the back of the pump, counter clockwise until you hear a release of air.
- Page 6 Operating Instructions Continued Needles Attach appropriately sized needle (included) to the luer lock tip of the filter/wand assembly. Needles can be used for both suction and pressure wands. It is recommended that the larger diameter needles are used for the pressure wand and the smaller diameter needles are used for the suction wand.
-
Page 7: Troubleshooting
2. The circuit breaker tripped Properly back of the unit. 3. Call Oaktree for a new circuit 3. Fuse failure breaker. Note Do not open cabinet for service. Contact Oaktree Products, Inc. at 800-347-1960 for all repairs. -
Page 8: Replacement Parts
• Light Blue, 0.5” 23 Gauge (item# 5123-B) • Blue, 1” 25 Gauge (item# 5125-1-B) • Blue, 0.5” 25 Gauge (item# 5125-B) • 1.5” Polypropylene Flexible (item# 5123-B) Oaktree Products, Inc. 610 Spirit Valley East Drive Chesterfield, MO 63005 636-530-1664 800-347-1960 otp@oaktreeproducts.com...