Advertisement
SAFETY INSTRUCTIONS
READ
INSTRUCTIONS
-
All
the
safety
and
'operating instructions should be read before he
appliance is operated.
RETAIN
INSTRUCTIONS
-
The operating inst:
tions should be retained for tuture ceference.
HEED WARNING
—
Ail warnings on the appliance
and in the operating instructions should be adhered
to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be foltowed
WATER AND MOISTURE — The appliance should
not be used near water — for example, near a
bathtub, washbow!, kitchen sink, laundry tub, in a
wet basement, or near a swimming pool. etc
LOCATION — The appliance should be installed in a
stable location.
WALL OR CEILING MOUNTING — The appliance
should not be mounted to a wall or ceiling.
VENTILATION ~ The appliance should be situated so
that its lacation or position does not interfere with
its proper ventilation. For example, the appliance
should not be situated on a bed, sofa, rug, or
similar surface that may block the ventilation apen-
ings; or, placed in a built-in installation, such as a
bookcase or cabinet that may impede the flow of
air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources such as radiators, heat registers,
stoves, or other appliances (including amplifiers!
that produce heat.
POWER SOURCES — The appliance should be con-
nected to a power supply only of the type describ-
ed in the operating instructions or as marked on the
appliance
POWER-CORD PROTECTION
— Power-supply cords
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cords
at plugs, convenience receptacles, and the point
where they exit from the appilance.
POLARIZATION
. .
If your purchased product is pro-
vided with 4 polarized power plug, please read the
following instructions. This product is equipped
with 4 polarized alternating current fine plug (a plug
having one blade wider than the other). This plug
will fit mito the power outlet only one way. This 1s 3
safety feature
if you are unable to insert the plug
fully vito the outlet, try reversing the plug ff the
plug should sui fail to fit, contact your electrician
to replace your obsolete outlet. De not d e t e a t
the
safety purpose of the polarized plug.
CLEANING
The apotance
should be cleansed only
with 4 golishing gloth or a sot dry cloth, Never
clean with furiture wax.
benzine, insecticides
or
other volatle liquids since they may corrode the
cabinet
[ {MPORTANT 1
The lightning flash with arrowhead,
within an
equilateral triangle. 15 intended to alert the user of the
presence of uninsulated "dangerous voltage" within the
product's enclosure shat may be of sufficient magnitude
to constitute a risk of eleciric
shock to persons
POWER LINES — An outdoor antenne should be
located away from power lines.
NONUSE PERIODS — The power cord of the ap-
pliance should be unplugged from che outlet when
left unused for 3 long period of time.
OBJECT AND LIQUID ENTRY — Care should be
taken so that objects do not fall and liquids are not
spilled into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by Pionee: authorized service
center or qualified service personnel when:
*
The power-supply cord or the plug has been
damaged: or
*
Objects have fallen, or liquid has been spilled into
the appliance; or
The appliance has been exposed to rain; or
The appliance does not appear to operate normally
or exhibits a marked change in performance: or
*
The appliance has been dropped; or the enclosure
damaged
SERVICING — The user should not attempt to service
the appliance beyond that described
i n the
operating instructions. For all other servicing, con-
tact the nearest Plone' authorized service center
ie
POWER LES
service
ENTRANCE
CONCUCTOR: Sy
Grou
wane a8,
GROUND
SERVICE ENTAANCE
cars
iouiewent
Power service
GROUNDING ELECTRODE SYSTEM
fe iierior meted water aie?
BONDING
TOMPER
FIG.A
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT QPEN.
CAUTION
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE
PARTS INSIDE
REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL
TOEATERNAL ANTENNA
TERMINALS OF PRODUC?
ANTENNA,
DISCHARGE UNIT
ROUKD
ee
cusses,
REQUIRED @y
LOCAL CODES. see
WEE SECTION 1031
|
OUTDOOR ANTENNA GROUNDING ~ 11 an
outside antenna
is conn
ach to the anienna
lerminal.
Se sure the sntenna
system
ss
grounded se as to prowde some prote
against voltage suges and pudt up srane
charges
In the U.S 4 section $19 of the Navonal Elec
trea! Code, ANSUNFPA No 70-1984, pro:
vides information
with respect
te prope:
grounding of the mast and supporting
struc
Lure, grounding of the lead.in wire to an anten
na discharge unk, size of grounding conduc
tors, location of antanna- discharge unt,
con
nection ta grounding electrodes,
and ve
quirements for the grounding #lectrade, $
Fig. A.
2} Use No. 10 AWG (5.3 mm')
copper, No 8 AWG (8.4
mm) alursnurn, No
17
AWG (10 mm
copper
clad steel, bronze wire. ot
larger 8s ground wire
db) Secure antenna lead.
and
STAND-OFF
ground wires to house with
BUSULATORS ©
stand off insulators spaced
from 4 feet (1.22 maters) to
6 tear (1.83 meters) apart
c)
Mount
antenna
dis
unit as closely a& possible to
ANTENNA,
TeaD In wine
where lead-in enters house
d) Use jumper wre not smaller
than No.6 AWG 113.9 mm}
copper or equivalent when
separate antenna ground
ang electrode ws used
The exclamanon point within an equilateral inangle &
intended to aledt the user of the presence of mpariaet
operating ard maintenance (servicing! i
the Iherature accompanying the apphan:
IMPORTANT 2
ff the apparatus is fitted with AC mains power outlets),
see REAR PANEL FACILITIES for convenient connec-
tion of additional Hi-Fi componentis}. Make all connec-
tions to the AC outlet(s) and the signal terminals first.
Connect the plug to the wail socket last, make sure that
the power switch is off. Disconnect the wall plug when
the equipment is not in (regular) use, e.g. when on
vacation,
The power switch is secondary connected and therefore
does not separate the unit from mains power in STAND-
BY (tone arm on the rest} position.
2
<PRB-308>
FOR USE IN THE UNITED
KINGDOM
WARNING: This plug must only be connected to
electronic apparatus equipped with suitable
sockets.
if not, cut off the plug and fit an appropriate type
in accordancs with the instructions below.
The cut-off plug must be disposed of as an elec-
trical shock hazard could exist if connected to a
socket outiet.
The wires in this mains tead are coloured in accordance
with the following code
Biue:
Neural
Brown
Live
As the colours of the wires int the cains lead of this ap
paratus may not correspond with the coloured marking
identifying the tecminals in your plug proceed as
follows:
The wire which 1s coloured blue must be connected to
the terminal which s marked with the fetter N or col
oured black
The wire which is coloured brown must be connected to
the terminal which is marked with the letter | or col
Oured red.
Advertisement
