Technics SA-AX910 Operating Instructions Manual page 19

|
Enjoying sound with DOLBY PRO LOGIC
ees
i
AAA AA AA AA AAA IAA AI AI
by remote control only
i
t
|
i Press TEST to output a test signal.
i The speaker outputting the test signal is displayed while the
| test is running.
L: Front speaker (left)
C : Center speaker
R : Front speaker (right)
i S : Surround speakers
OFF/ON.
L—C—R—S§S
Ld)
For 3 STEREO mode
L—C—R
fo JJ
by remote control only
Press VOLUME (4) or (-) to set the volun level
normally used for enjoying the source.
The following steps are for setting the output level of the
i
For SURROUND mode
|
i
|
| front speakers and the center/surround speakers to the same
listening level.
by remote control only
Press CH SELECT to select the center or surround
speakers.
........ AAA AA AA AA 6 by remote control only
Press DA or OQ to adjust the output level.
—: Decrease the output level.
+: Increase the output level.
Output level can be varied within a range of -12 dB te +12 dB
]
|
i
}
|
!
|
!
}
1
| with front speaker output level serving as the zero point.
| Note |
| . | 1. The test signal is output only by the speaker you are now
CH SELEGT . adjusting and does not repeat the sequence until
| adjustments are complete.
i 2. Remember you cannot adjust output level of the surround
| | speakers if you selected the 3 stereo mode in step 1.
+ : To stop the test signal"
Press TEST.
OA i = To turn off the Dolby Pro Logic systems
topi Press OFF/ON
ou Press once again to turn it on.
Output level
|
1
ace