Advertisement
Available languages
Available languages
Model #:
Voltage
Frequency
ASH
VACUUM
Power
INSTRUCTIONS FOR USE
IMPORTANT NOTES:
*
Each use, verify that HEPA filter is in place and that HEPA seal
plate wing nut is tight. Always test seal by vacuuming up a small
amount of ash while located away from living areas
** Do not attempt to use vac to remove large piles of ash from a
fireplace or wood stove. Instead remove bulk of ash with a shovel
and ash can (or hod) and then use the ash vac for final cleanup.
1. Plug cord into outlet, (see photo 2 bellow).
2. Press the on/off button to switch the appliance on (see photo
1 bellow).
3. For fireplaces and wood burning stoves see "important note
**", above. Place nozzle in firebox. Keep nozzle pressed against
the flat surfaces of stove or fireplace to limit entrance of large
chunks into pickup tube.
4. When finished cleaning turn switch off, photo (see photo 1
following) .
5. Remove the plug from the outlet (see photo 2 following) and
take vacuum to an outside location away from valuables and
breezes.
6. Release the flexible hose from the air intake duct. A Small
amount of ash may be generated so be carefull (see 3
following).
1
7. Verify ash is cold! Allow to cool further if needed, then dump
debris. Ash is a great garden supplement!
8. Every 3 to 5 uses, clean HEPA filter while outside and away
from valuables. Take the filter out for cleaning (see step
below) or change. Follow the four steps below for taking off
the filter.
NOTE: This process will be dusty. Pictures depict a clean machine
for illustrative purposes.
AC02586
110 V
60 Hz
1000 W
2
3
9. Cleaning filter - to limit dust place HEPA filter inside a plastic
bag (not included). To clean filter, tap gently against a hard
surface. Empty plastic bag and inspect filter. Dust within
the filter pleats may require gentle flexing of the filter by
squeezing the filter's rubber seals so as to make the filter oval
instead of round. Tap filter while "Out of round" to get deeply
set dust out of pleats.
Follow steps in point 8 for re-assembly of the filter.
10. IMPORTANT - with filter installed and lid in place turn
vacuum on at a dry outside location to test filter seal. Look
for dust at the exhaust port. A small amount is normal after
cleaning filter. Vacuum up a small amount of ash while still
outside to give final assurance of a good seal and to verify
filter integrity. Replace filter if dust passes though at this point.
SootStop Pre-filter extends the life of HEPA filter. Most helpful
with pellets stoves.
See step below for installation:
FILTER CARE: Filter may be washed or simply shaken out. Replace
if holes in fabric develop.
3
Advertisement
