Page 1
Sliding roof canopy Instruction manual SIZE:L392xW305xH207/H262cm CAN0033 IMPORTANT You must read these instructions carefully before you start to assemble this Sliding roof canopy .Please ensure that you find all parts. in the carton box in the correct type and quantity as mentioned in the list illustrated in every page accordingly.
SAFETY ADVICE TOOLS & EQUIPMENT REQUIRED We strongly recommend the use of work gloves during assembly. Protective Equipment: Do not attempt to assemble the Sliding roof canopy in windy or wet conditions, Do not touch overhead power cables with the aluminum profiles. 1.Helmet Always wear shoes and safety goggles when working with extruded aluminum.
PRODUCT SIZE Make sure a good installation location OTHER CAUTIONS 1. 3 people required, one is for measuring & taking marks to ensure the installation dimension ,the second person is responsible for the installation and the last one do as assistant and assure the safety.
PARTS LIST SKELETON CONNECT NO. Qty. NO. Qty. NO. Qty. 2870mm 2870mm 2870mm 3914mm 3914mm 3914mm SCREW NO. Qty. NO. Qty. 2100mm F2 146 F2-1 30 2531mm Fixed screw should be purchased according to different ground.
Page 5
SUMMARY STATEMENT FOR POLYCARBONATE PANEL WINDOW WINDOW A x2 WINDOW B x2 WINDOW C x2 Install schematic diagram of Alu.frames Towards the white film side to the sun as it is UV-protected.
Page 6
B3R x1 B3L x1 2 x2 F2 x24 B5 x4 Drain outlet facing forward. Ⅰ F2 x4 Do not tighten the screws.
Page 7
Silicon B2 x2 F2 x12 S1 x2 Ⅰ Ⅱ Ⅰ Silicon Silicon Do not tighten the screws.
Page 8
3 x2 F2 x24 B5 x4 Ⅰ F2 x4 Do not tighten the screws.
Page 13
Make sure the frame on the ground, then install the windows. Window B Upward view Window A Window A Window B Window B Window C Window C Window C Ⅰ Window A Ⅱ Ⅲ Window B Window C -13-...
Page 21
F2 x16 F6 x16 B1 x4 Ⅱ Ⅰ Ⅲ Ⅳ 1.Choose the location of the installation. 2.Make No. 2 and No. 3 vertical to the ground. 3.Mark the position of No. 2 and No. 3 on the ground, then move away the canopy. 4.Put B1 on the position of No.
Maintenance: In a timely manner the centralizer skeleton. 1.If the ground not level off, loose soil layer thickness is differ, wall shed may tilt to one end, once found, should be timely the centralizer, in case of deformation. The shed may be slant when facing the un-level ground or loose soil layer, please righting the shed urgently to avoid deformation 2.Prevent increased loading-weight artificially.
Need help?
Do you have a question about the CAN0033 and is the answer not in the manual?
Questions and answers