Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
PRODUCT SAFETY & LEGAL DISCLAIMER
•
IMPORTANT READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY.
•
Review the product package and contents prior to beginning the installation. Take care when opening the
packaging and removing items. If a return is needed you will want to return the product in its original
packaging if possible.
•
This instruction guide is provided as a GENERAL installation guide, some vehicles vary dimensionally and
may require additional steps.
•
Test fit the product on the vehicle prior to any third party modifications and or finishing. The manufacturer
and/or distributors do not accept responsibility for third party charges, labor and or third part replacement
modifications. Some modifications may void the factory warranty.
•
Exercise due-diligence when installing this product. The manufacturer and distributors of this product do
not accept any responsibility for vehicle damage or personal injury resulting from the installation of this
product. Careless installation and operation can result in serious injury or equipment damage.
•
This product is for general off-road use. All liability for installation and use rests with the owner/operator.
•
INSTALLER: Once installation is complete, please return this guide along with other documentation included
in this product back to the consumer for future reference. The manufacturer/distributors of this product do
not guarantee this particular version will be available at a later date.
www.gorhino.com
© 2016 Go Rhino Products. All rights reserved
589 W. Apollo St., Brea, CA 92821
PART NO.
PRODUCT DESCRIPTION:
Blackout Series
Blackout Series Combo
Bright Series
Flash Series
P: 888 427 4466
Advertisement
Table of Contents
Summary of Contents for RHINO XPLOR Blackout Series
- Page 1 The manufacturer/distributors of this product do not guarantee this particular version will be available at a later date. © 2016 Go Rhino Products. All rights reserved www.gorhino.com 589 W. Apollo St., Brea, CA 92821...
- Page 2 Factory sensors may read shackles or hooks protruding from the fairlead and or tow hooks. • All sensor testing is completed by Go Rhino Products and or third party testing labs on modified vehicles. • Sensor sensitivity, factory sensor housing, orientation, and operating conditions are all variables that will influence functionality of the sensors.
- Page 3 Yellow: Amber Position Light Green: Amber Strobe Light Black: Negative Go Rhino recommends you, the installer, read this installation instruction manual from front to back before installing the product. You may also click here to view an installation video or visit http://www.gorhino.com/Installation-Videos.
- Page 4 WIRING INSTRUCTIONS RELAY NEGATIVE FUSE SWITCH POSITIVE CONNECTOR STEP 1: When routing wire harness through any metal surface be sure it is free of any sharp edges and protected using wire sheathing or a grommet. STEP 2: Route the harness through vehicle, connect the XPLOR lamp by directly plugging into the Deutsch connector’s that are pre-terminated onto the harness.
- Page 5 TROUBLESHOOTING After installation, if the lamp does not activate → Check the wiring and make sure there are no faulty or irregular connections . If the switch illumination does not light up. • Verify the (+) wire from the switch is properly connected. If it is not correctly connect it will not activate.
- Page 6 This warranty covers the cost of the product only and does not include the cost of removal, installation, third party modifications or shipping of the product. In no event shall Go Rhino be liable to buyer or any third party for any damage or harm caused by the product or use thereof, regardless of weather such damages were foreseeable and whether or not Go Rhino has been advised of the possibility of such damages, not withstanding the failure of any agreed or other remedy of its essential purpose.
Need help?
Do you have a question about the XPLOR Blackout Series and is the answer not in the manual?
Questions and answers