Maintenance Instruction - Chicago Pneumatic CP858 Series Operator's Manual

1.Technical Data
Power Free speed
Model
1 2
[Hp] [W] [RPM]
max. pressure 6.3bar(90psi)
a k
h
Declaration of noise and vibration statement
2. Machine type(s)
3. Operation
• Fix the accessories properly to the tool.
• Connect device as shown in Fig. 01.
• To start the machine, pull the trigger (A). Machine speed is increase by increasing pressure on the trigger. Release the trigger to stop.
• Do not install a quick coupler directly into the sander throttle handle.
4. Lubrifi cation
Use an air line lubricator with SAE #10 oil, adjusted to two drops per minute. If an air line lubricator cannot be used, add air motor oil to the inlet once a day.
Recommended lubricant : CP Oil PROTECTO-LUBE
- 4 oz (0.12l) P/N: CA149661
- 20.8 oz (0.591l) P/N: CA000046
- 1gal (3.8l) P/N: P089507

5. Maintenance instruction

• Follow local country environmental regulations for safe handling and disposal of all components.
6. Disposal
• Repair only by technical maintenance staff.
7. Declaration of conformity
Machine type(s): belt sander
Declare that the product(s): CP858
Origin of the product : JAPAN
is in conformity with the requirements of the council Directives on the approximation of the laws of the Member States relating : to "Machinery"
applicable harmonised standard(s) :
Name and position of issuer :Nicolas Lebreton (R&D Manager)
Place & Date : Saint-Herblain, 04/06/2015
Original Instructions are in English. Other languages are a translation of the original instructions.
Copyright 2015, Chicago Pneumatic Tool Co. LLC
Belt capacity Dimension
LxW LXH
w H
W
L
3 4
[inch]
[inch]
L K
pA pA
Serial Number: 00000 - 99999A
EN ISO 11148-8:2011
Air Consumption
Air Inlet
Average at load
5 6 7
[inch]
K
WA
Inner Hose
Dia.
8 9
[inch]
2006/42/EC (17/05/2006)
K
10 11