Advertisement
the reasons shown in the table, the service may be charged in some cases.)
No operation occurs when
operation keys are pressed.
No sound is heard from the
headphones.
Sound
skips, or is inter-
rupted.
Noise interferes.
Rechargeable
batteries
cannot be recharged.
malfunction.
* The HOLD /RESUMNE
switchof the main
unit or remote
controliier
is set to
ai HOLD",
e The batteries are exhausted.
e The disc /s placed upside down.
e Condensation occurred inside the unit.
e The AC adapter ts unplugged.
* The headphones are connected incom-
pletely.
* Ths volume is set to the minimum posi-
tion on the main unit or remote control-
ler.
* The system is !ocated subject to vibra-
tion.
* The disc is dirty.
e The lens is dirty.
* The headphone plug ts dirty.
* The batteries are weak.
* The headphone plug is dirty.
e The batteries are weak.
« The headphones are connected incom-
pletely.
« Commercially-available
rechargeable
batteries are used,
« Set the switch to other position than
"HOLD",
e Replace both of the two dry cell
batteries, or recharge the recharge-
able batteries.
Place the cise with the labeled side
Up.
e Leave the unit for about 1 hour be-
fore re-use.
e Connect properly.
* Insert the plug securely into the
PHONES jack.
« Adjust the volume on the main unit
or remote controller,
* Place the unit in a place not subject
to vibrations.
« Clean it.
« Clean it.
e Clean it.
« Replace or recharge the batteries.
* Clean it.
« Replace or recharge the batteries.
e Insert the plug securely into the
PHONES jack.
* Use the exclusive rechargeable bat-
teries (NB-77/NB-88},
Advertisement
