Advertisement
Quick Links
Radioddity X6100-H1 Protection Bracket Installation Guide
Preparation
Please note you need to prepare a cross screwdriver.
Installation Steps
(1) Unscrewing the Side Panel: Using a Phillips head screwdriver, carefully remove the four
screws that are securing the side panel. You can refer to the provided figure for visual
guidance.
Note: Be sure to store the screws in a safe place for future use.
(2) Positioning the Gasket: Next, take the gasket and align it with the four screw holes from
which you just removed the screws. The provided figure can help you ensure correct
placement.
Advertisement
Summary of Contents for Radioddity X6100-H1
- Page 1 Radioddity X6100-H1 Protection Bracket Installation Guide Preparation Please note you need to prepare a cross screwdriver. Installation Steps (1) Unscrewing the Side Panel: Using a Phillips head screwdriver, carefully remove the four screws that are securing the side panel. You can refer to the provided figure for visual guidance.
- Page 2 (3) Installing the Protective Handle: Now, gently place the protective handle that you prepared earlier onto the side panel. Make sure to align the handle with the screw holes. Once aligned, proceed to tighten the screws with the equipped hex wrench. Please pay attention to the direction of the protective handle.
- Page 3 (5) Installing the Antenna Interface Waterproof Cap: Install the antenna interface waterproof cap. This can be done by hand, similar to tightening a screw. Ensure it’s securely fastened. Note that it’s important to handle all components with care to avoid any damage. Happy assembling! Handle Braiding Guide For a detailed guide, please refer to the video...
- Page 4 X6100 Tempered Glass Screen Protector Installation Guide Preparation Clean Your X6100 screen: Work in a clean and well-lit area. Clean your hands thoroughly with warm water and hand soap to remove dirt and grime from your hands. Dry them on a clean towel before you start installing the tempered glass.