Page 1
Continuous Ink Supply System CANON PIXMA IP6000 Installation Instruction For ST Prefilled Version This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole operation is very easy. It’...
Page 2
CIS for CANON PIXMA IP6000 Instruction Thank you for purchasing DP Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges.
Page 3
3、Installation Procedures: 1) First step Put CISS on the left side of the printer. In the meantime, place all the tubes at correct position. Then pull the small rubber plug out of Air hole, and insert the air filters into air holes as the pictures shown above. 2) Install cartridges Pls turn on power.
Page 4
Too long is no good. Twisted line is no good. Install well. 4、Refill Ink Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the ink refill holes (There is possibility of ink spattering.
Need help?
Do you have a question about the PIXMA IP6000 and is the answer not in the manual?
Questions and answers