Maximum S.E.S. Series Assembly Instructions

Hide thumbs

S.E.S. SERIES ENCLOSURES – ASSEMBLY INSTRUCTIONS

Thank you for purchasing our Maximum Reptile

These instructions will walk you through the complete assembly of your new enclosure.

Before you begin, make sure that you have all the parts, including Panels #1-8, and your enclosed

accessory kit that contains the screws, lock and door handle. If you notice that anything is missing,

or has sustained damage upon delivery, please let us know before proceeding with assembly.

One Phillips head screwdriver

We recommend conducting assembly on the edge of a table or workbench. It is advised to

NOTE: If you're using an electric drill, be sure it is on the lowest setting, and that you do

not overtighten the screws. PVC is a soft material and it is quite easy to strip the thread.

This is why we recommend to use only a screwdriver, but it does take a little longer.

For the assembly of this unit, you'll need:

ENCLOSURE ASSEMBLY

put a towel down to prevent scratching of any surfaces.

Begin by aligning Panels #1 and 2 as shown. We have

already pre-drilled all the alignment holes for you in our

workshop, so these parts will go together easily. It's

important to make sure the ends are upright and flush with

Panel #1. The screw holes in both panels will align

accordingly.

S.E.S. Series Enclosure!

Table of Contents

Need help?

Do you have a question about the S.E.S. Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Maximum S.E.S. Series

Page 1 S.E.S. SERIES ENCLOSURES – ASSEMBLY INSTRUCTIONS Thank you for purchasing our Maximum Reptile S.E.S. Series Enclosure! These instructions will walk you through the complete assembly of your new enclosure. Before you begin, make sure that you have all the parts, including Panels #1-8, and your enclosed accessory kit that contains the screws, lock and door handle.
Page 2 2. Now repeat the same steps on the other end, attaching Panel #3 to the unit, making sure again that the #2 Panel is flush with the front. 3. After Panels #2 and 3 are securely fastened, add the back face to the assembly, which is marked as Panel #4.
Page 3 It is now time to assemble the internal hood. Locate Panels #6 and #7 and screw them together as shown. It is important to make sure that the rear of these parts are aligned as show. 7. With the enclosure on its back, you can now align the internal hood assembly with the slots.
Page 4 11. The front (marked Panel #8) is the last part to add. Begin by inserting the bottom of this panel first, and slowly push it into the groves. This will be a tight, precession fit and is easier to do with the front screws left out for now (see step 5).
Page 5 Note, glass doors do not need the optional security bars. If you plan to stack these enclosures, we recommend purchasing the optional stacking kit so that they enclosures will stay aligned when stacked up. CONGRATULATIONS - you have now fully assembled your Maximum Reptile S.E.S. Series Enclosure We thank you for your patronage! Should you run into any issues or have questions regarding this assembly, please feel free to reach out to our customer service team for assistance.