Lincoln industrial MP1 Owner's Manual

Owner’s Manual
Operating Instructions
Change-over Valve Model MP1

Table of Contents

Safety instructions ........................................................... 1
Structure ........................................................................... 1
Erection and assembly .................................................... 2
Operating instructions ..................................................... 2
Technical data .................................................................. 2
Troubleshooting ............................................................... 3
Single parts ...................................................................... 4
Manufacturer’s declaration ............................................. 6

Safety Instructions

Appropriate Use
• The change-over valve is exclusively designed for use in
centralized lubrication systems.
• Do not exceed the maximum ratings mentioned in the
Technical Data, particularly the maximum operating
pressure.
• Any other use will not be conform.
• The manuafacturer is not responsible for damage resulting
from incorrect use.
Operation of the Change-over valve
• The change-over valve should be used only if it is in a good
state.
• Defects which impair the function and the safety must be
remedied to immediately.
• The function of the change-over valve is only guaranteed if
clean hydraulic oil and lubricant are used.
• If you require more information than mentioned in this
Owner’s Manual, Please contact us (see address at the
bottom of the page).
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Pneumatically Operated
Page
Maintenance and Repairs
• Before executing maintenance and repair work at the
change-over valve read the Owner’s Manual and the
Safety Instructions.
• The Owner’s Manual must be available at the place where
the unit is in operation.
• Alterations or modifications of the change-over valve are
only allowed if approved by the manufacturer.
• Use only original spare parts for repair work.
• If other parts are used, the manufacturer may be released
from his liability for the resulting damage.
Structure and Mode of Operation
The change-over valve operates like a hydraulically operated
4/2-way valve which alternately discharges the lubricant fed
by the pump into one of both main lines, while the other main
line is connected to the return line connection of the pump.
Fig. 1: MP1 used as a change-over valve for two-line systems
1.3A-48001-A00
1029c95
Page 1 of 6