僅 Operating Rear Window Wiper And Washer Switch - Kia Sedona 2024 Owner's Manual

Features of your vehicle
僅 Do not put pressure on the windshield
glass.
CAUTION
僅 When washing the vehicle, set the
wiper switch in the OFF (0) position to
stop the auto wiper operation.
The wiper may operate and be dam-
aged if the switch is set in the AUTO
mode while washing the vehicle.
僅 Do not remove the sensor cover
located on the upper end of the pas-
senger side windshield glass. Damage
to system parts could occur and may
not be covered by your vehicle war-
ranty.
僅 When starting the vehicle in winter,
set the wiper switch in the OFF (0)
position. Otherwise, wipers may oper-
ate and ice may damage the wind-
shield wiper blades. Always remove all
snow and ice and defrost the wind-
shield properly prior to operating the
windshield wipers.
僅 When tinting the windshield, be care-
ful of any fluid getting into the sensor
located in the top center of the front
windshield. It may damage the related
parts.
4 128
Operating rear window wiper and
washer switch
The rear window wiper and washer
switch is located at the end of the wiper
and washer switch lever.
僅 Turn the switch to the desired position
to operate the rear wiper and washer.
OKA4042506N
- HI - Normal wiper operation
- LO - Intermittent wiper operation
- OFF - Wiper is not in operation
僅 Push the lever away from you to
spray rear washer fluid and to run the
rear wipers several times.
OKA4042404N
The spray and wiper operation will con-
tinue until you release the lever.
When the front wiper is activated and
the gear is switched to R (Reverse) posi-
tion, the rear wiper will be activated once
to provide better visibility.
Wipers and washers