Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Drying time too long?
Display panel goes out
and Start button flashes.
Humidity in the room is
increasing.
Power failure.
Unusual noises when dry-
ing.
The dryer feels cold
despite drying.
* Depending on the model
If you cannot rectify the fault yourself by turning the dryer off and then on
Note:
again, please contact our after-sales service.
32
Cause/remedy
The fluff filter or the EasyClean filter may be dirty, which will make the dry-
■
ing time longer. Clean the fluff filter or the EasyClean filter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy saving mode is active ~ Page 12.
Not a fault. Make sure the room is adequately ventilated.
The drying programme is stopped. Remove the laundry and spread it out, or
restart the programme.
Not a fault; see also ~ Page 29.
Not a fault. The dryer can dry effectively at low temperatures using a heat pump.
Advertisement
Table of Contents
