Royal CPR 28T Installation, User And Maintenance Manual page 36

2 SAFETY WARNINGS
2.1 INSTALLATION WARNINGS
The boiler assembly and dismantling instructions are
reserved exclusively for specialist technicians.
Users should always contact our service centre to
Before having work performed by other technical
personnel verify their effective technical competence.
Responsibility for work carried out in the place where
the boiler is installed lies with the user; the user is also
responsible for making sure the installation checks are
completed.
The user must abide by all local, national and European
safety requirements.
suitable load-bearing capacity.
Make sure that the flue and air intake duct
arrangements correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed correctly.
Before starting to assemble or dismantle the boiler, the
installer must heed the safety precautions required by
A) do not work in adverse conditions;
and make sure that personal protective equipment
is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
2.2 MAINTENANCE WARNINGS
manual.
other means of protection.
that the boiler, if it had been operating, has cooled
down.
calibrated or not working, the boiler must be
considered out-of-service.
Disconnect power before working on electrical or
electronic parts and connectors.
2.3 WARNING FOR THE USER
Prepare the boiler installation site in accordance
with local, national and European regulations.
As the boiler is a heating appliance it has very hot
outside surfaces. For this reason maximum care
do not touch or get too close to the door to avoid
getting burned;
do not perform any type of cleaning;
36
INTRODUCTION
do not remove the ash;
do not open the door;
do not open the ash bin;
make sure children keep away from the boiler.
manual.
Follow the instructions and warnings highlighted
These labels are safety devices, therefore they
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
shown in the corresponding chapter of this
manual.
Strictly follow the routine and special maintenance
plan.
"Maintenance" in this manual.
Do not use the boiler in the event of malfunctions,
suspected breakage or unusual noises.
Do not pour or spray water onto the boiler when
Do not switch the boiler off by unplugging the
power cord.
Do not rest your weight on the open door as this
may affect stability.
Do not use the boiler in any way as a support or
anchor.
Do not clean the boiler until the structure and ash
have completely cooled down.
Touch doors only when the boiler has cooled
down.
Perform all operations without haste, in such a
way as to ensure maximum safety.
off using the procedure described later.
procedure described in the Maintenance chapter.
Maintenance chapter.
Do not touch the painted parts during operation
to avoid damaging the paintwork.