Table of Contents
Advertisement
Introduction
FCC Information
Federal Communications Commission (FCC)—
This equipment complies with both Part 15 and Part 68 of the FCC rules.
Part 68
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back cover of this
equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this
information must be provided to the telephone company.
•
A plug and jack (RJ11C) used to connect this equipment to the premises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided
with this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation
instructions for details.
•
The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs
should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total
RENs, contact the local telephone company. For products approved after July 23, 2001, the REN for this product is part of the
product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point
( e.g. , 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.
•
It is unlikely, but if your DST-3100 causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. But, if advance notice isn't practical, the telephone company will
notify the company as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it
is necessary.
•
The telephone company may make changes in it's facilities, equipment, operations, or procedures that could affect the
operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
•
If trouble is experienced with your DST-3100 , for repair or warranty information, please contact
Products, Inc. at 1 (888) 867-4377.
request that you disconnect the equipment until the problem is resolved.
This equipment Does Not contain any user serviceable parts. All repairs should be performed only by Toshiba Authorized Service
station personnel.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or
corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of your DST-3100 does not
disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a
qualified installer.
Electrical Safety Advisory:
You should consider adding a surge arrestor prior to the AC input and telephone line of your DST-3100. Telephone companies report
that electrical surges, typically lightning transients, are very destructive to customer terminal equipment connected to AC power
sources. This has been identified as a major nationwide problem.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection
authority, or electrician as appropriate.
Part 15
FCC Declaration of Conformity Compliance Statement (Part 15)
The Toshiba DST-3100 DIRECTV
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
that may cause undesired operation.
The responsible party for compliance to these rules is: Toshiba America Consumer Products, Inc. 82 Totowa Rd.,
Wayne, NJ 07470, Ph: (888) 867-4377.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying
power to the equipment, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
6
If the equipment is causing harm to the telephone network, the telephone company may
®
High Definition Receiver/HDTV Tuner complies with Part 15 of the FCC rules. Operation is subject
Toshiba America Consumer
Advertisement
Table of Contents
