Siemens WM6HXE0PDN User Manual And Installation Instructions page 49

Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
i-DOS error, deactiv-
ate i-DOS
"E:30 / -10" and/or
All other error codes.
Cause and troubleshooting
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 15
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 45.
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 43
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 45
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 47
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 43
Switch the appliance on.
3.
If the display appears again after you clean the
4.
pump unit, call customer service.
→ "Customer Service", Page 60
Note: You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→ "Buttons", Page 25
The filter in the water inflow is blocked.
Clean the water inflow filter.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 60
Troubleshooting en
49