Siemens LC 901 Series Operating And Installation Instructions page 20

Filters and maintenance
Activated carbon filter:
For neutralizing odours in recirculating
mode.
Inserting the filter:
1. Remove the metal filters
(see "Removing and inserting the metal
grease filters").
2. Insert the activated carbon filter.
3. Engage the catches at both sides.
4. Insert the metal grease filters (see
"Removing and inserting the metal
grease filters").
5. Cancel the in the display.
ã
Press the 0 button.
20
Saturation indicator:
When the activated carbon filter reaches
saturation point, an acoustic signal is
sounded for 10 seconds after the fan has
switched off, and a
ã
display. The activated carbon filter should
be replaced straight away.
Removing the filter:
1. Remove the metal filters.
2. Press the catches at both sides of the
filter inwards and lift the carbon filter
down and out.
3. Insert the metal grease filters.
Replacing the activated carbon filter:
A replacement filter can be obtained
from any authorized dealer (see optional
accessories).
Use original filters only.
By doing so you will obtain maximum
performance from your extractor hood.
Disposing of the old activated carbon
filter:
There are no pollutants in the activated
carbon filters. They can therefore be
disposed of as part of your normal
domestic refuse.
appears in the