Table of Contents
Advertisement
HYUNDAI
"BOOST" Mandatory Operations:
1) If with correct connection between Jump Starter and vehicle battery (Red LED keeps on and green LED
is off), press and hold BOOST button for 3 seconds (after a buzzer sound, the green LED is on and red
LED is off). Usually this is because the vehicle battery capacity is rather low.
2) Start the engine (same method as the normal operations in Page 6).
Cautions:
!
1) Under normal circumstances, do not use the mandatory operations.
2) The spark proof, reverse polarity protection and short circuit protection features are disabled after Boost
button is pressed. Pay very close attention to the polarity of the battery before using this mode.
Do not allow the positive and negative battery clamps to touch or connect to each other as the item will
generate sparks and high heat if not used properly.
LED and Buzzer Communication:
No.
Red LED
Green LED Buzzer Sound
1
On
2
Off
3
Slow flash
4
Slow flash
5
Fast flash
6
Fast flash
7
Off
8
Off
Off
One sound
On
One sound
Off
No buzzer
Off
No buzzer
Off
Fast buzzer
Off
Fast buzzer
Fast flash
No buzzer
Fast flash
No buzzer
Jumper cable and HYPS-600 are connected.
Jumper cable and vehicle battery are connected.
Ready to start the engine.
Lithium battery voltage in HYPS-600 is rather low.
Have not turned on the ignition switch within the regulated
time. To resolve this, you need remove clamps from vehicle
battery, and connect again when No.1 condition occurs.
Red and black clamps are connected with each other.
Reverse connection of clamps.
Engine is started.
Vehicle's battery voltage is higher than Jump Starter's.
Condition
07
Advertisement
Table of Contents
