Havit HV9101-ZB-5C Instructions

HV9101-ZB-5C
RGB CCT DIM 3 in 1 Zigbee Remote Controller
Important: Read All Instructions Prior to Installation
Function introduction
ON/OFF button, click to turn ON/OFF all, press
and hold down to search and pair to ZigBee
network or factory reset the controller
Press and hold down to
increase light intensity
Press and hold down to
cycle RGB colors, click
to get R, G, B one by one
www.havit.com.au
Press and hold down to
decrease light intensity
Press and hold down to
adjust color temperature
between WW and CW,
click to get 100% WW,
100% CW one by one
Note: This remote supports
1 group for binding max. 30
Front side
lighting devices.
CR2430 battery
Back side

Product Data

Operation Voltage 3VDC
Power Supply 3V(CR2430 battery)
Transmission Frequency 2.4GHz
Transmission Range (free field) 30m
Protection Type IP20
Dimming Range 0.1%-100%
ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
• Basic • Power Configuration • Identify
Output clusters:
• Identify • On/off • Level control
Safety & Warnings
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.

Operation

1.This ZigBee RGB+CCT remote is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
2.This ZigBee remote supports 1 group for binding max. 30 lighting devices and enables to control both
RGB and CCT ZigBee lighting devices.
3. Zigbee Network Pairing through Coordinator or Hub (Added to a Zigbee Network)
Step 1: Remove the remote from
previous zigbee network if it has
already been added to it, otherwise
pairing will fail. Please refer to the
part "Factory Reset Manually".
Step 3: Press and hold down until
LED indicator turns on.
• RGB+CCT+DIM ZigBee remote controller based on
ZigBee 3.0
• Supports 1 group for binding max. 30 lighting devices
• Supports TouchLink to pair to a lighting device directly
• 2.4 GHz global operation
• Long battery life mesh technology
• Transmission range up to 30m
• Compatible with ZigBee Gateway products
• Enables to bind and control universal DIM, CCT, RGB,
RGBW and RGB+CCT zigbee lighting devices
• With magnet on the back, easy to be absorbed on
metal surface
• Diagnostics
• Ota • Color control
Step 2: From your zigbee
controller or hub interface, choose
to add device or accessory and
enter Pairing mode as instructed
by the controller.
Step 4: Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network.
Indicator will then blink 5 times
quickly for successful pairing.
www.havit.com.au www.havit.com.au