Advertisement
Advertisement
Table of Contents
Related Manuals for ChamSys 10Scene
Summary of Contents for ChamSys 10Scene
- Page 1 10Scene Gateway Installation and Configuration Guide Model: 300-056...
-
Page 2: Product Overview
System Configuration Options 10Scene wall mounts can be daisy chained together up to 10 per cable run. The 10Scene Gateway has 2 10Scene ports, allowing a total of up to 20 10Scene wall mounts to be connected to the device. Each 10Scene port supports a contact close switch, with configuration within the MagicQ or QuickQ software determining its function. - Page 3 CAT5e Brown pair (twisted Wall plates together) Pin 1 Pin 5 When facing the 10Scene Ports on the Gateway, Pin 1 is found on the left (towards the Power/Comms LEDs). A Contact close switch is wired between Pins 2 & 5.
- Page 4 Pin 7 Pin 1 If daisy chaining, twist 10Scene High IN and the OUT wires together and connect to Pin 3, and twist 10Scene Low IN and the OUT wires together and connect to Pin 4. When 10Scene Wall Mounts are first connected to a 10Scene Gateway the front panel...
- Page 5 For QuickQ consoles/racks, Gateways are configured in the 10Scene, Gateways window. 10Scene gateways ship from the factory with a default 10.x.x.x IP address, with a /8 subnet (255.0.0.0). For system programming refer to the MagicQ or QuickQ software manuals found on the...
-
Page 6: Fcc Part 15 Notice
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You may also consult your local ChamSys Ltd dealer or an experienced radio/TV technician for assistance. NOTICE: The FCC regulations provide that any changes or modifications not expressly approved by ChamSys Ltd could void the user’s authority to operate the equipment. - Page 7 WEEE Producer registration number WEE/FF5605UX. 10Scene Warranty The 10Scene Gateway comes with a two-year parts and labour warranty which covers the device for component/material failure. This warranty does not cover physical damage caused by damage in transit or damage to components caused by factors such as liquid damage/spills onto the console.
Need help?
Do you have a question about the 10Scene and is the answer not in the manual?
Questions and answers