Table of Contents
Advertisement
14. Do not let cord hang over edge of table or counter or touch hot surfaces.
15. Do not place on or near a hot gas or electric burner or in a heated oven.
16. Do not use appliance for other than intended use.
Important Cord and Plug Information
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to
fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse it. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way. A short power supply cord is provided to reduce the risk resulting from
becoming entangled in or tripping over a longer cord. DO NOT USE WITH AN EXTENSION CORD. Do not allow the cord to run
underneath or around the appliance. The magnetic cord may not detach easily if the cord is positioned in this fashion. Connect the
power supply cord to a 120VAC electrical outlet only.
How to Attach Legs and Handles
Tools Required: #2 Phillips screwdriver
Parts Included: 4 Legs, 2 Handles
To Attach Legs to Base
1. Place the appliance upside down on the table or counter.
2. Using the screwdriver, remove the screws from the four mounting projections on the bottom of the appliance and set aside. Use
these screws to attach the legs to the base.
3. Position one of the legs, rubber foot facing up, over one of the mounting projections (Fig. A). Align the hole in the leg with the
hole in the mounting projection and fasten securely with the screw. The leg should not rock or move if twisted.
NOTICE: Continuing to tighten, once secure, can result in the stripping of screws or the cracking of legs.
4. Repeat step 3 for the other three legs. When properly assembled, it should sit level with no leg rock.
To Attach Handles to Base
1. Place the appliance upside down on the table or counter.
2. Using the screwdriver, remove the screws from the tabs on each side of
the base and set aside. Use these screws to attach the handles to the base.
HINT: When removing the screw under the plug guard, hold the
screwdriver at a slight angle or use a short screwdriver or a screwdriver
with a long shank.
3. Slide one of the handles, with the screw hole facing up, onto the tab so the
hole on the tab aligns with the hole on the handle (Fig. A). Fasten securely
with the screw. The handle should not wobble, but slight movement from
side to side is normal.
NOTICE: Contunuing to tighten, once secure, can result in the stripping of
screws or the cracking of handles.
4. Repeat step 3 for the other handle. When properly installed, the handles
should appear parallel with the table or counter.
To Attach Basket Handle
1. Slide lock bar up on handle (Fig. B) and place one
of the handle bars into one of the tabs on the bracket.
Then squeeze the handle bars together and fit the other
handle bar into the opposite tab on the bracket.
2. After attaching the handle to the basket, make sure to
slide the lock bar down (Fig. C) to the locked position
to ensure against accidental detachment of the handle
from the basket.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.
Fig. A
Leg
Mounting
projection
Tab
Fig. B
Lock
bar
Handle
bar
2
Screw
Handle
Fig. C
Lock bar
Tab
Rubber
insert
Plug
guard
Screw
Screw
hole
Tab
Advertisement
Table of Contents
