HP 59501A Operating Manual page 3

5. For operation as a power supply programmer:
a. Find the correct wiring diagram below, cor¬
responding to power supply model number, and
either CV or CC mode of operation. (See Table 1).
b. Arrange the barrier strip jumpers on the power
supply as illustrated in the diagram.
c. Remove internal jumpers or components from
the power supply if diagram requests.
d. Wire the 59501A to the power supply as il¬
lustrated.
e. Set range switch on power supply if applicable.
f. Before permanently wiring the power supply to
the 59501A, check the power supply operating
and service manual for proper wiring technique
and external components which may be needed
to insure ripple and noise specifications.
6. For operation as a DC source:
a. Wire load to 59501A as illustrated in Figure 2.
Figure 2. Connecting the 59501A as a
Low Level Voltage Source.