Table of Contents
Advertisement
5. Remove the
solid-state
6. Remove the
wireless
card.
7. Remove the
memory
modules.
8. Remove the
system
board.
NOTE:
The system board can be removed as an assembly with the fan and heat-sink assembly, ethernet and audio
board, and USB board attached.
About this task
The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the removal
procedure.
Steps
1. Disconnect the left and right-fan cables from the system-board assembly.
2. Turn the system-board assembly over.
3. In sequential order (1>2>3>4>5>6>7), remove the seven screws that secure the fan and heat-sink assembly to the system-
board assembly.
4. Lift the fan and heat-sink assembly off the system-board assembly.
72
Removing and installing Field Replaceable Units (FRUs)
drive.
Advertisement
Table of Contents
