Table of Contents
Advertisement
en Troubleshooting
Fault
Buzzing noise.
The drying time is too
long.
Water is leaking from
the appliance.
The laundry is too
damp.
40
Cause and troubleshooting
Compressor ventilation active.
Not a fault – normal operating noise.
▶
Fluff filter is soiled.
→ "Cleaning the fluff filter", Page 29
▶
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
The ambient temperature is lower than 15 °C.
Ensure that the ambient temperature is above 15
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
Not a fault.
1.
Do not pull out the condensation tank.
2.
Do not cancel the programme.
3.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 24
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 24.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Advertisement
Table of Contents
