Table of Contents
Advertisement
en Installation and connection
ATTENTION!
If the appliance is installed in areas
exposed to frost or outdoors, frozen
residual water may damage the appli-
ance and frozen hoses may crack or
split.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost and/or outdoors.
The appliance underwent a function
test before leaving the factory and
may, therefore, contain residual wa-
ter. This residual water may leak out
if the appliance is tilted at an angle
greater than 40°.
Tilt the appliance carefully.
▶
Installation loca-
tion
On a base
On a wooden
joist floor
14
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 32.
Place the appli-
ance on a water-
resistant wooden
board which is
screwed tightly to
the floor. The
wooden board
should be at
least 30 mm
thick.
Installation loca-
tion
In a kitchen unit
On a wall
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡ Please read the information in the
Safety → Page 4 and Preventing
material damage → Page 10 sec-
tions to ensure that you use the
appliance safely.
¡ Keep the transit bolts, screws and
sleeves in a safe place for future
transport → Page 58.
Requirements
¡ A niche width
of 60 cm is re-
quired.
¡ Only install the
appliance un-
derneath a
continuous
worktop that is
securely con-
nected to adja-
cent cabinets.
Note: If the cov-
ering plate is re-
moved, the metal
covering plate
→ "Accessories",
Page 32 must
be secured be-
fore installation.
Do not trap the
hoses between
the wall and the
appliance.
Advertisement
Table of Contents
