Download Print this page

Gardco Quadracycle Instructions

Drying time recorder

Download this manual

P A U L N G A R D N E R C O MP A N Y

9 1 0 4 G U I L F O R D R O A D , S U I T E H

E MA I L G A R D C O @A L T A N A . C O M

C O L U MB I A , MD 2 1 0 4 6 U S A

P H O N E + 1 - 9 5 4 - 9 4 6 - 9 4 5 4

Need help?

Do you have a question about the Quadracycle and is the answer not in the manual?

Page 1 P A U L N G A R D N E R C O MP A N Y 9 1 0 4 G U I L F O R D R O A D , S U I T E H E MA I L G A R D C O @A L T A N A .
Page 2 Operating Controls On/Off Button Press to turn the Quadracycle On or Off. When the On/Off button is pressed and the Green LED is illuminated to note the instrument is ready for testing. If the On/Off button is held down for two seconds while the instrument is testing the current test will be terminated and the Red LED will illuminate.
Page 3 2. Balane the arm by adjusting the rear counterweight before placing the 12 gram weight on the ball shaft. 3. Apply the coating to your test panel using a Gardco Microm Film Applicator or other wet film applicator. 4. Immediately place the Drying Time Recorder on your test panel and lower the clean 3/8 in.

11326