Related Manuals for IndeeLift PPU-S
Summary of Contents for IndeeLift PPU-S
- Page 1 PPU-S (People Picker Upper – Standing) USER MANUAL INDEELIFT, S.L. INDEELIFT, INC. Barcelona, SPAIN 5143 Tesla Road Livermore, CA 94550 international@indeelift.com USA 844-700-5438 www.IndeeLift.com www.IndeeLift.com...
-
Page 2: Table Of Contents
Physical Specifications: ......................18 Electrical Specifications: ......................18 Owner’s Notes: ......................... 19 IndeeLift – the first human floor lift designed and engineered to alleviate the grief, hazards and hassles of recovering from a fall! Page 2 of 20 Copyright 2023 IndeeLift, Inc. All Rights Reserved... -
Page 3: Safety Symbols
The PPU-S is a floor-to-stand (FTS) lift designed for self or assisted operation in the home or care environments. This appliance can lift a person up to 300 pounds (136 kg). This unit is referred to as the “PPU-S” throughout this manual. -
Page 4: Ppu-S Features/Functionality
Small Footprint and Easy Portability The PPU-S is a portable lift that is rolled around on wheels like a traditional dolly. The small footprint allows it to be positioned in many places other lifts simply cannot go. With a turning radius of 34” (86 cm), the PPU-S can go just about anywhere including most small bathrooms and hallways. -
Page 5: Ppu-S Component Identification
AC power cord into a standard AC wall power outlet, (see Preparing the PPU-S for use on Page 8). A full charge takes about eight hours. The control system will provide a beep tone when operated and batteries are in need of being charged. -
Page 6: Wired Remote
Power cords could cause strangulation. Keep young children from playing with or around the PPU-S to avoid mishaps that could result in death or serious injury. The wired remote control is connected to the PPU-S with a coiled cord and is used to raise and lower the seat by pressing the up or down button. -
Page 7: Rise-Assist Handles
PPU-S User’s Manual Rise-Assist Handles The rise-assist handles provide support and balance when standing from the seat or when using the PPU-S in a standing mode. The rise-assist handles are positioned on the lower bracket for seated operation and on the upper brackets for standing operation. - Page 8 Some users may have mobility challenges that will not allow them to reach rearward and push both levers forward simultaneously. The PPU-S comes with a Lock Release Bar assembly that can be attached to allow a single hand to lift the Lock Release Bar to disengage the seat lock.
-
Page 9: Preparing The Ppu-S For Use
Unpacking the PPU-S: The PPU-S comes packaged for shipment in an L-shaped carton that is sealed with shipping tape. The unit ships without the wheels attached. Packed inside the shipping carton will be the PPU-S, a corrugated box that holds the wheels, the rise-assist handles, the seat lock release bar mechanism, and the user manual which is packaged with both the AC power cord that connects to the battery charger and the wheel components. - Page 10 Once fully assembled, tighten each screw to ensure they are secure (Fig C). See illustration of Seat Lock Release Bar below. Fig B Fig C Installation of Seat Lock Release Bar Page 10 of 20 Copyright 2023 IndeeLift, Inc. All Rights Reserved 08/2023...
-
Page 11: Charging The Battery
Position the PPU-S near a standard commercial AC wall power outlet. Attach the female end of the AC power cord to the connector on top of the PPU-S’s battery charger. Fig 2 Attach the male end of the AC power cord to a standard commercial AC wall power outlet. Fig 3 The LED light on the battery charger will illuminate green within 15 seconds. -
Page 12: General Ppu-S Operation
PPU-S before they use it to lift themselves or someone else. These are the basic operational steps for using the PPU-S to lift a person from the floor to allow them to stand up or transfer to or from another seat. - Page 13 1) Follow steps 1-3 above. 2) Once the person being lifted is fully seated in the center and to the rear of the PPU-S’s seat, and their hands are resting on the rise-assist handles. The person being lifted, or a helper depresses and holds the “UP”...
- Page 14 The helper then assists the user to slide to the PPU-S seat. If the assisted person is unable to slide safely, a transfer board may be slid under the user to assist in the transfer.
-
Page 15: Standing Function
In assisted living or skilled nursing environments, a few inches of lift can get a patient onto an exam or x-ray table. The PPU-S provides a safe and reliable method to rise those few inches to reach that space that was out of reach without the PPU-S. -
Page 16: Securement Belt Information
PPU-S when being lifted, or anyone with neuromuscular conditions that may limit their lower body strength or their ability to stay on the seat unassisted). The belt assemblies can also be used simply as desired for additional safety when lifting an individual. -
Page 17: Maintenance
As the seated person is being lifted, have them gradually move their legs inward, then ensure their feet are properly positioned before they stand up from the PPU-S’s seat, (as the would from any chair). -
Page 18: Troubleshooting / Service
PPU-S User’s Manual Troubleshooting / Service: The PPU-S was designed to provide years of trouble-free performance. There are no user serviceable parts. However, should you encounter a situation where the unit is not operating properly, please ensure you have correctly followed the procedures for recharging the unit (covered in the Charging the Battery section of this manual on Page 9). -
Page 19: Warranty Information
PPU-S User’s Manual Warranty Information: IndeeLift, Inc. warrants to the original purchaser that this product and the components thereof will be free from defects in workmanship and materials for a period of one year from the original date of purchase. - Page 20 PPU-S User Manual For more sales and technical information refer to: https://IndeeLift.com or scan the bar code: Refer to videos about the entire IndeeLift family of products on our website Copyright 2023 IndeeLift, Inc. All Rights Reserved 08/2023...