Installation Instructions - Blomberg WTI 7400 Instruction Manual

least 3,5mm. After installation the disconnection device has
to be easy to reach.
 The connection to the mains must be carried out by a quali-
fied technician in accordance to the scheme shown below
and the regulations in force
 In the event of damage to the supply cord, it has to be re-
placed by the manufacturer or an authorized technical ser-
vice center in order to avoid any risk.
The manufacturer declines all responsibility for injury or
damage caused by failure to comply with the above regula-
tions or deriving from tampering with even just one part of the
appliance and the use of non-original spare parts.

2. INSTALLATION INSTRUCTIONS

Important!
The appliance must be installed by a qualified engineer in
compliance with the relevant regulations.
The washer-dryer is heavy. Take care when lifting it.
2.1 UNPACKING
The unit on flexible mounts is fixed in place for transport using
the screws (A) on the rear of the washer-dryer, with the relative
plastic spacers (B). Once the screws have been removed, the
power supply lead can be used.
EN
L
= b ro w n
N
= b lu e
= y e llo w -g re e n
9