Panasonic CF-50 Series Operating Instructions Manual page 32

Reinstalling Software
32
Do not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing Ctrl + Alt + Del, as
this may prevent Windows from starting up, or may cause data to be
lost so that the reinstallation procedure cannot be executed.
J After the reinstallation procedure completes, the screen should appear.
Remove the Product Recovery DVD-ROM, and then press any key.
The computer will be shut down.
K Turn on the computer, and press F2 while [Panasonic] boot screen is dis-
played.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password.
L Press F9.
At the confirmation message, select [Yes] and then press Enter. (The
Setup Utility settings will return to their default values. Even the security
settings with the exception of the password(s) will return to their default
values.)
M Press F10.
At the confirmation message, select [Yes] and press Enter.
N Select [Exit] and then select [Save Current Values], then press Enter.
At the confirmation messages, select [Yes] and press Enter.
O Turn the computer off by using the power switch.
If additional instructions are included with the computer, be sure to
read them. It may be necessary to perform additional operations during
the following procedures.
P Perform the first-time use operation. (
Q Run the Setup Utility and change the settings where necessary.
Changing the drive letter
You can change the drive letter for the CD/DVD drive or hard disk drive by the
following steps.
Drive letters can only be changed when two or more partitions have been
created on the hard disk drive. The name of the C: drive cannot be
changed.
We recommend that you make these changes before installing applica-
tions.
A Select [start] - [Control Panel] - [Performance and Maintenance] -
[Administrative Tools] - [Computer Management].
B Select [Disk Management] from [Storage].
C Right click on the partition of the hard disk or the name of the CD/DVD
drive and select [Change Drive Letter and Paths...].
D Select [Change].
E Select [Assign the following drive letter] and the new drive letter, and then
select [OK].
F At the confirmation message, select [Yes].
page 12)