Electrolux EWF 1045 Instruction Booklet page 19

132991680 GB.qxd 28/10/2003
10. Start the programme
Press the START/PAUSE button. The relevant light
will stop flashing. The message relevant to the
phase that is in progress will be shown in the
display.
If you have chosen a delayed start, the washing
machine will begin the countdown.
START/PAUSE
11. How to change a programme during
its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the
programme carries it out.
When the programme has started, you can only
reset it by turning the programme selector dial to
«O» and then you can select the new programme.
The washing water remains in the tub.Start the new
programme by depressing the START/PAUSE
button.
Note: To drain the water before starting the new
cycle you have to cancel the programme and select
the DRAIN cycle.
12. Cancelling a programme
Turn the selector dial to «O» to cancel a programme
which is running. Now you can select a new
programme.
13. How to open the door during the
cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
the washing machine is not in the heating phase
beyond 55°C;
the level of the water is not high;
the drum is not turning.
13:50 Pagina 19
COTTON 08.30
Washing 12.00
40°C 1200
Temp. Spin Options Change Exit
If these requirements are met, when you pause the
washing machine, the relevant message appears in
the display and the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by turning the selector dial on "O"
position.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
14. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal (if
option no sound has not been selected), and
displays the relevant message.
If you had selected the RINSE HOLD or NIGHT
CYCLE option, the START/PAUSE button light is off.
To drain or spin first turn the programme selector
dial to «O» and then to drain programme
spin/delicate spin programme
Release of the lock is also indicated by the coming
on of the message "Door openable" (cycle ended).
Turn the programme selector dial to «O» to switch
the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking)
or bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
19
or
/ .